Administration for Children and Families
OF HEALTH AND HUMAN SERVICES
|1. Log No. ACF-PI-HS-07-02
||2. Issuance Date: 02/06/2007
|3. Originating Office: Office of Head Start
|4. Key Word: Playground Use Zone Safety
TO: Head Start and Early Head Start Grantees and Delegate Agencies
SUBJECT: Standards for Playground Use Zone Safety
The purpose of this Program Instruction is to address the Head Start Program Performance Standards requiring grantees and delegate agencies to provide for the maintenance, repair, safety, and security of facilities, materials, and equipment as well as to maintain playground surfaces that minimize the risk of injury to children. The information clarifies program practices that presumptively comply with the Federal safety requirements at 45 CFR §§ 1304.53 (a)(7) and 1304.53 (a)(10)(x).
All Head Start grantees and delegate agencies are expected to comply with applicable State, Tribal, or local codes governing playground equipment and surfaces where children are present. Public school or public playgrounds used by Head Start programs must comply with all safety requirements prescribed by applicable local laws. In those cases where there is no applicable code, regulation, or requirement, in order to comply with 45 CFR §§1304.53 (a)(7) and 1304.53 (a)(10)(x), grantees and delegate agencies are expected to meet the minimum specifications described in the Consumer Product Safety Commission (CPSC) Handbook for Public Playground Safety , (Chapter 4.5) as such describes the minimum requirements of various surfacing materials to avoid risk of injury to children.
We urge Head Start programs to take immediate action to comply with the standards for playground surfaces specified in the CPSC Handbook in those cases where there are not already local safety standards and to be mindful of potential liability for children’s injuries. For those jurisdictions not already covered by State, Tribal, or local law, beginning in January 2008 we will monitor compliance against the minimum standards for playground surfaces specified in the Handbook for Public Playground Safety.
Head Start program regulations at 45 CFR 1304.53 (a)(7) require Head Start grantees and delegates to “provide for the maintenance, repair, safety, and security of all Early Head Start and Head Start facilities, materials, and equipment” and 45 CFR 1304.53 (a)(10)(x) requires grantees and delegates to “select, layout, and maintain playground equipment and surfaces to minimize the risk of injury to children.” The Office of Head Start has long recognized the potential hazards associated with the use of playground equipment, especially injuries resulting from falls from such equipment. Based on review of monitoring review reports, it appears there is significant variance among grantees related to the actions taken to avoid injuries to children associated with falls from playground equipment.
Playgrounds are an important part of children’s educational experience and should be safe and secure. Unfortunately, according to the Consumer Product Safety Commission, annually more than 200, 000 children are treated in hospital emergency rooms for injuries sustained from falls to the ground from playground equipment. Because many children’s injuries are preventable through the proper use of protective surfacing under and around outdoor play equipment, the Office of Head Start believes an increased emphasis on the importance of protective surfacing is critical.
The CPSC has conducted studies and developed recommendations about standards for appropriate playground surfaces which will minimize child injuries. The surface material beneath and around playground equipment (the “use zone”) can be a major factor underlying the injury potential of a fall. Falls onto shock absorbing surfaces are less likely to cause serious injury than are falls onto hard surfaces. In particular, head injuries from falls are potentially life threatening and the more shock absorbing a surface is, the greater likelihood the risk of severe injuries can be avoided.
You will note the CPSC Handbook (available on-line at http://www.cpsc.gov/cpscpub/pubs/325.pdf) identifies the required depth of various injury protecting surfaces in direct relation to the critical height of the playground equipment children use. For example, a depth of 6 inches of uncompressed re-engineered wood chips should be maintained for use zones under any equipment from which a child could fall seven feet. While the CPSC describes and provides for surface maintenance of all playground equipment for all children, equipment should be adapted for use by very young children in accordance with age appropriate use and safety.
The CPSC Handbook provides a safety inspection check list which we encourage grantees and delegate agencies to use on a regular basis. While Head Start regulations at 45 CFR 1304.53 (a)(10) require grantees and delegates to conduct annual safety inspections, we encourage Head Start programs to make frequent regular inspections of playground areas to ensure that children are adequately supervised and prevented from leaving play areas, that equipment is in good repair, and that surfaces are clear of debris and protect children against injuries from scrapes or punctures.
Among the terms used in the CPSC Handbook that we recommend programs gain familiarity with are the following:
Critical Height: The fall height below which a life threatening head injury would not be expected to occur.
Infill: Material(s) used in a protective barrier to prevent a user from passing through the barrier, e.g., vertical bars, lattice, solid panel, etc.
Loose-Fill Surfacing Material: A material used for protective surfacing in the use zone that consists of loose particles such as sand, gravel, wood fibers, or shredded rubber.
Protective Surfacing: Surfacing material in the use zone that conforms to the recommendations in section 4.5 of the CPSC Handbook for Public Playground Safety.
Unitary Surfacing Material: A manufactured material used for protective surfacing in the use zone that may be rubber tiles, mats, or combination of rubber-like materials held in place by a binder that may be poured in place at the playground site and cures to form a unitary shock absorbing surface.
Use Zone: The surface under and around a piece of equipment onto which a child falling from or exiting from the equipment would be expected to land.
Finally, please note the Office of Head Start maintains a toll-free help line for all facilities related consultation and we encourage you to call for additional guidance and support. You may call 866-763-6481 for this assistance.
Office of Head Start
See PDF version:
Standards for Playground Use Zone Safety [PDF, 333KB]